As you receive training and support, or go through the Blueprint Help Desk you'll begin to hear (or read) more and more about Smart Tag. This section is where you will setup your default Smart Tag settings. Remember, you can always override your default settings within the job for each Smart Tag Session.
Choose whether you want Blueprint to automatically head size or assign an aspect ratio when capturing images.
Automatic Head Sizing
This option allows you to automatically apply the head sizing feature as images are pulled in from your hot folder.
Automatic Aspect Ratio
The following options are available when applying an automatic aspect ratio:
- 2:3 (4x6)
- 2.5:3.5 (5x7)
- 4:5 (8x10)
- 1:1 (10x10)
Primary Image Selection
Select which image you would like to set as the Primary Image.
First Image - This will make the very first image shot for each subject the Primary Image.
Last Image - The final image shot in the Smart Tag session will be the Primary Image.
Barcode Scan Field
Choose which field you would like the barcode to scan for. This will allow you to scan onsite and jump directly to the subject.
ID (System ID)
Custom Data 1
Custom Data 2
Custom Data 3
Decide which information is being listed with the subject data on the Smart Tag screen.
Subject Data Preview
Select which data is visible when a subject is selected. Select up to five fields.
Camera Hot Folder
The hot folder is where Blueprint will look to find images while shooting tethered. You will need your Camera's utility software installed, so you can point to the directory where you'd like your camera to dump images. This should be the same folder Blueprint is pointed to.
When Enable Watching is enabled, images will be added to Blueprint immediately after your camera dumps the images into the hot folder.